In case you serve wine generally to your company, you might want a glass rack in your dining room. A wall-mounted wineglass holder is an great rack for positioning over a hutch or sideboard table. The benefit of just reaching for cups will allow you to display a sophisticated evening conveniently. Make a discussion article by setting up your special wall-positioned wineglass rack. A handful of pieces of timber and some fundamental instruments are usually all you need to set-up an powerful rack that has a shelf over for a small art piece or cork group.
1. Location the 1-by-12-by-24-inch oak board on a work area. Measure and mark the plank at 6, 12, and 18 inches. This is the rack support board.
2. Site a 1-by-2-by-12-inch oak board on a work surface. Line-up a 1/2-by-1/2-by-12-inch oak board in the core of primary panel to make sure that they are parallel. Make this happen for all six boards. These are the position assemblies for the rack.
3. Position two slot assemblies on each pencil symbol on the rack aid board. The assemblies should extend to the width of the support plank. Place the 1/2-inch side of the assembly down. Leave a 3/4-inch space between the 2 assemblies. This will likely allow the stalks of the glasses to slide between them. Push finish nails into the assemblies to attach them to the support board. Space the nails evenly every 2 inches. The nails must go down through the core of both slot assembly boards into the support board.
4. Sand the wineglass rack with fine-grit sandpaper. Sand with the grain.
5. Employ a timber surface finish. Let the surface finish to dry out prior to touching.
6. Pick a destination to build the rack over a wall. Line up the brackets 22 inches apart on the wall. Mark the holes with a pencil. Screw the brackets to the wall.
7. Target the rack on the mounting brackets. Bolt the mounting brackets to the bottom of the rack.
8. Slide the glasses directly below the rack between the slot assemblies.
1. Location the 1-by-12-by-24-inch oak board on a work area. Measure and mark the plank at 6, 12, and 18 inches. This is the rack support board.
2. Site a 1-by-2-by-12-inch oak board on a work surface. Line-up a 1/2-by-1/2-by-12-inch oak board in the core of primary panel to make sure that they are parallel. Make this happen for all six boards. These are the position assemblies for the rack.
3. Position two slot assemblies on each pencil symbol on the rack aid board. The assemblies should extend to the width of the support plank. Place the 1/2-inch side of the assembly down. Leave a 3/4-inch space between the 2 assemblies. This will likely allow the stalks of the glasses to slide between them. Push finish nails into the assemblies to attach them to the support board. Space the nails evenly every 2 inches. The nails must go down through the core of both slot assembly boards into the support board.
4. Sand the wineglass rack with fine-grit sandpaper. Sand with the grain.
5. Employ a timber surface finish. Let the surface finish to dry out prior to touching.
6. Pick a destination to build the rack over a wall. Line up the brackets 22 inches apart on the wall. Mark the holes with a pencil. Screw the brackets to the wall.
7. Target the rack on the mounting brackets. Bolt the mounting brackets to the bottom of the rack.
8. Slide the glasses directly below the rack between the slot assemblies.
About the Author:
Want to find out more about Wine glass rack, then visit Peter parker's site on how to choose the best under cabinet glass rack for your needs.
No comments:
Post a Comment